王中王精选六肖中特

Service Hotline: 18053469992
180-5346-9992

List of products in the current section:

> 玻璃钢水箱 > Your current location : 王中王精选六肖中特 > FRP water tank >

SMC glass fiber reinforced plastic water tank manufacturing process

Release Date: July 01, 2019Keyword: FRP Water Tank
FRP fire water tank is assembled by SMC moulded water tank board. Because of the use of food-grade resin, it has the characteristics of good water quality, clean and pollution-free, high strength, light weight, corrosion resistance, beautiful appearance, long service life, convenient maintenance and management. The glass fiber reinforced plastic fire water tank factory produced by our company is the first batch of products recommended by the National Building Materials Industry Bureau and the Ministry of Construction [1999] No. 330 document, which fully meets the technical performance requirements of the National Building Industry Bureau standard JC658.1-2003. The water tank has been tested by the relevant state departments. The water tank meets the requirements of the "Safety Evaluation Standards for Drinking Water Transmission and Distribution Equipment and Protective Materials", and the water quality conforms to the national "Drinking Water Standard."
FRP fire water tank manufacturer manufacturing process
The prepared raw materials are compounded according to the prescribed ratio, and then the slurry is stirred to form a resin paste; the prepared resin paste and glass fiber yarn are impregnated into an SMC sheet through an SMC sheet unit; after 48 hours of heating and curing, inspection Sheets are cut, weighed, stacked according to the required specifications, and evenly spread in a mold that has been cleaned and heated to 120-140 ° C for compression molding and holding pressure for a certain period of time according to technical requirements. Formed SMC veneer, inspect the SMC veneer after grinding and trimming; SMC veneer that has passed the inspection is punched with mounting holes for packaging, storage, and storage; SMC molded veneers are installed according to their positions. Hole rubber seals and stainless steel brackets (ribs) are assembled into an SMC combined water tank for inspection; if the inspection is qualified, it is a finished product.