List of products in the current section:
FRP water tank installation steps
Release Date: July 01, 2019Keyword: FRP Water Tank
FRP water tank installation steps
1.Inventory the goods
According to the bill of materials, check the steel components of the base, bolts, nuts, fixed slats, angle steel, seals, ribs, water inlets and outlets, etc., and take inventory and make records.
2. Make the foundation.
The constructor refers to the following figure (the layout diagram of the base of the SMC water tank and the foundation) as the foundation, and the foundation can be used only after the foundation is accepted. The plane of each foundation stay shall be leveled so that it is on the same plane, and the error shall not exceed ± 0.5cm.
3. Welding base.
The base is welded according to the size of the water tank, and its size is consistent with the size of the bottom plate of the water tank. After the channel steel is completely welded, the size is measured diagonally with an error of ± 0.5cm.
4. Install the bottom plate of the box.
According to the number and description on the water tank board, arrange and connect the bottom plate of the water tank. At the same time, add a sealing tape between the two boards and connect them with φ10 bolts. Make the bottom plate tightly sealed. When applying the bolts, apply them in sequence and evenly. Do not use excessive force at one time, or tighten a single bolt first, otherwise the board will crack due to uneven force. The bottom plate and the channel steel base are connected with a fixed angle, so that the water tank body is more firmly fixed on the channel steel foundation.
5. Install the facade.
According to the printed number and labeling instructions on the glass fiber reinforced plastic water tank single board, find out the layer number of each layer of the water tank, separate them in order from bottom to top, and assemble the surface with bolts. Set the water tank plate upright, make it right, so that the Bang board and the bottom plate form a 90-degree angle, and add sealing tape to tighten the bolts.
6. Install the inner ribs.
According to the size of the water tank, choose the number and length of the ribs. Use a lacing plate to measure the lacing of the lacing to the wire, draw a picture, make a hole, and tighten the lacing, so that the lacing is flat and balanced with the water tank. If there is a large error between the box and the ribs, you can adjust the error by adjusting the bolt tightening degree until the error is minimized.
7. Install the cover.
Install the water tank cover and fasten the bolts evenly. Do not use too much or too little force. After adjusting all the fasteners of the water tank, open the water pipes according to the drawing opening positions and attach the flanges to connect the valves.
8. Installation of accessories
After the water tank is installed and formed, internal and external ladders should be installed, and the internal ladder should be placed in the water tank. The outer ladder is fixed on the side plate of the box. The installation of the water tank inlet and outlet, overflow, and sewage pipe is the same as the conventional method.
9. Water tank test inspection.
After the installation of the water tank is completed, a unified inspection and adjustment are carried out for a 24-hour hydrostatic test, and no leakage is considered acceptable. After passing the test, it is cleaned and disinfected and delivered for use.
★ Related articles:
- Whether the price of FRP water tank is calculated in cubic or square
- FRP water tank manufacturers tell you what factors affect the price of water tanks
- Precautions in the use of FRP water tank
- How much is a cubic meter of SMC FRP water tank?
- When purchasing FRP water tanks, have you encountered the following:
Address: Dezhou City, Shandong Province Phone: 18053469992 GOOGLE Map